AUTONET TV

Battery Basics for Lansing

It's important for Lansing drivers to know battery basics. First, let's talk about which is harder on a battery – hot or cold Michigan weather. Most Lansing area drivers think it's cold weather because that's when we call on our batteries to have enough power to start a cold vehicle engine.

However, heat does more damage to a battery than cold. Truth is, our batteries start to die a little from day one. Keeping a full charge slows the process, which is hard with short Lansing trips because the alternator doesn't have time to fully recharge the battery from starting the engine. Lansing drivers can top off the charge with a computer controlled battery charger – say, once a month in the summer and every three months during the winter.

As far as how long a battery will last, statistics show that 70% have given up the ghost within four years. By that time, they aren't capable of taking a full charge like they used to, and your vehicle alternator has to work overtime to keep up. This causes your alternator to wear out early.

If you're pushing 4 to 5 years on your battery, see your friendly and knowledgeable AutoSurgeonInc service assistant for a battery test to see if it's recommended to replace it. Not only can you avoid getting stranded with a dead battery on a Michigan road, but you'll save unnecessary wear and tear on your vehicle alternator.

Give us a call.

AutoSurgeonInc
1820 E Kalamazoo St
Lansing, Michigan 48912
517-374-8940

Don't Stack the Mat

In the sloppy cold weather months, you might be tempted to pick up an all-weather mat and throw it on top of the mats you already have in your vehicle. After all, double protection is better, right? In this case, wrong. Here's why.

It's important to keep the accelerator and brake pedals clear so they can function the way they are supposed to. Stacking mats in the driver's side footwell can make them sit up too high on the floor. That can, in turn, jam your accelerator pedal forward, causing your vehicle to unintentionally speed up; it may get stuck in that position. Same thing applies to the brake pedal. The mats can get caught underneath it and prevent you from stopping.

Here are some other good practices when it comes to mats. It's best to get those designed for your vehicle. They are shaped to fit your specific car, truck, van or SUV. Ill-fitting mats can have the same untended consequences as stacked mats.

Good mats will have either a Velcro-type fastener on the back of them or a hook that fits into a hole in the mat. That way, the mat stays affixed to the floor so it doesn't slip and cause problems.

One more thing to keep in mind. If you have objects rolling around your vehicle, let's say under the driver's seat, just think about what happens when you jam on the brake. That object is thrown forward and can get caught in a pedal. You might find the accelerator stuck or the brake pedal inoperative.

Your service advisor at AutoSurgeonInc can recommend the right mat for your vehicle. The right mat may save your carpeting, the wrong one may cost you an accident.

AutoSurgeonInc
1820 E Kalamazoo St
Lansing, Michigan 48912
517-374-8940

Make your Service Visit at AutoSurgeonInc a Good One

Most people don't love going to get their vehicle serviced, but it's one of those things you just have to do. So you might as well get the most of out of it. There are some steps you can take that will likely help you get the best results possible.

For one thing, it's important to describe your problem (or problems) to the service advisor accurately and clearly. If your vehicle is making a noise, for example, take time to really listen to it and think of the best way to describe it. Does it increase in speed when you go faster? If you feel a vibration somewhere, where in the vehicle does it seem to originate? Some service advisors recommend writing things down. That way the driver won't forget any important clues that could lead to a successful resolution of the problem.

Another thing is to make sure your vehicle is cleaned out and free of junk. That way the technician can access those nooks and crannies where some vital components may be. If your vehicle is full of strollers, boxes or your collection of fast food containers, it won't be easy for the technician to reach some of those parts. Oh, and if your vehicle is neat, it does send a signal that you really care about it.

Finally, stay out of the way of the technician. A recent survey of technicians reveals they work more efficiently and do a better job when they don't have someone hanging on their every move. Can you imagine how you'd feel if someone hovered over you all day while you were trying to get your work done?

AutoSurgeonInc
1820 E Kalamazoo St
Lansing, Michigan 48912
517-374-8940

The AutoSurgeonInc Guide to Tire Specs

You know you need new tires, but you're not sure what type. You look at a tire to get the size: 225, 50, R, 16, 92, H. All the way to the Lansing service center you keep repeating it over and over. You even say it over in your mind while waiting in line. Then you get to the counter and the manager asks what size you need. Then your mind goes blank.

Tire size can be confusing for many Lansing drivers. There's so much on the side of the tire, and it's hard to keep straight.

Even though there's a lot on a tire - if you know what it all means, it's actually more helpful than confusing for Lansing tire shoppers. Let's start with the size number.

For example, let's say a tire reads: 225 50 R 16 92 H. The 225 part is the width of the tire in millimeters - the width between the sidewalls of an inflated tire with no load. The 50 is the aspect ratio - the ratio of the sidewall height to the tread width. Off-road tires will have a higher number and high performance tires will have a lower number.

The R signifies it's a radial tire. And 16 is the rim or wheel size in inches.

The 92 is the load rating index - it's the load carrying capacity of a tire. The higher the number, the more it can safely carry. Your empty vehicle can be safe with a lower number, but you'll need a higher rating if you routinely haul heavy loads around Lansing. The next letter is the speed rating. Not all tires sold in Lansing are speed rated. The ratings generally follow the alphabet: the further up the alphabet, the higher the speed rating - with the exception of H - it comes between U and V (don't ask why).

There's a lot of fine print that most Lansing area drivers probably need a magnifying glass to read. But there are a couple of other large print items of interest. One is the tread type: highway, mud and snow, all season, severe snow, etc.

And then there are the Uniform Tire Quality Grading System markings. The first is a tread wear index. 100 is the base line - a lower number is poorer and a higher number is better. All things being equal, a tire rated 200 would wear twice as long, on a government test track, than one rated at 100. These wear grades are only valid within the manufacturers product line - you can't compare with others. And it's important to note that a lower rating might be just what you want - a high performance, sticky tire has a softer rubber compound and won't wear as long, but boy, will it take those corners on twisting Michigan roads.

The next is a traction grade. This measures the tire's ability to stop on wet pavement in government tests. A - the best, B - intermediate, C - acceptable.

Temperature grade measures a tire's resistance to heat buildup in government tests. A, B and C - from best to acceptable.

It's safe for Lansing drivers to go with the vehicle manufacturers original equipment recommendations that came on your car. But if you want to make adjustments, you'll now be better equipped to communicate with your friendly and knowledgeable AutoSurgeonInc tire professional.

AutoSurgeonInc
1820 E Kalamazoo St
Lansing, Michigan 48912
517-374-8940